wipers only work on high
Thread Starter
|
New User
Joined: Feb 2005
Posts: 2
Likes: 0
wipers only work on high
My windshield wipers will only work on high. Also they will not park. I have put power to the different terminals at the motor and can get them to work on low and high speeds. I replaced the switch thinking it may gave been the problem but it did not make any differance. Does anyone have a wiring diagram for the wiper system showing what each wire does. My diagram in my manual onle shows the wires. it does not show what they are for. Any suggestions would be greatly appreciated.
Post Fiend
Joined: Nov 2003
Posts: 21,285
Likes: 15
From: Nutter Fort, WV
What do you have for a truck?
If you go up to the blue bar and click "User CP" and then "Edit Signature" You can put the year tranny 2 or 4 wheel drive Reg extended or crew cab in there for all to see when you post. It makes things easier on everyone.
If you go up to the blue bar and click "User CP" and then "Edit Signature" You can put the year tranny 2 or 4 wheel drive Reg extended or crew cab in there for all to see when you post. It makes things easier on everyone.
Thread Starter
|
New User
Joined: Feb 2005
Posts: 2
Likes: 0
it is fixed now. Thanks all. The problem was that a previous owner had installed an aftermarket wiper delay and had pulled a wire out of the harness. when i put it back in i put it in the wrong position. I switched the wire to a different position in the harness and then the wipers worked fine. Thanks again
Thread
Thread Starter
Forum
Replies
Last Post
hanketsu
1987 - 1996 F150 & Larger F-Series Trucks
14
Mar 19, 2016 04:43 PM
ZukBox II
1973 - 1979 F-100 & Larger F-Series Trucks
9
Oct 11, 2010 03:01 AM
SCD
Explorer, Sport Trac, Mountaineer & Aviator
6
Mar 11, 2010 07:18 PM
jlag
1999 - 2016 Super Duty
6
Dec 9, 2003 07:48 AM
