driveshaft ?
Thread Starter
|
More Turbo
Joined: Nov 2004
Posts: 590
Likes: 1
From: in the woods of Maine!
driveshaft ?
I've cut me a new driveshaft myself, and it's got single joints on each end. I've heard that if your running single joints on both ends, both the yokes off the transfer output, and the rear end pinion have to be parrallel, or close to it.
-well my pinion angle is close to 0, and my transfer output angle is a little steep, not TOO bad though
so is this going to create a problem, w/ the different angles and such?
-well my pinion angle is close to 0, and my transfer output angle is a little steep, not TOO bad though
so is this going to create a problem, w/ the different angles and such?
