Custom SLA halfshafts?
Thread Starter
|
Senior User
Joined: May 2003
Posts: 210
Likes: 0
From: Whittier, CA
Custom SLA halfshafts?
Recently I bought via eBay an ARB air locker for the front end of my 2002 4x4 Ranger. Unfortunately, I didn't notice until it arrived that it's for 30-spline "performance" axles, rather than the a Dana 35's standard 27-spline axles. I'm probably going to end up trying to resell the thing, but I'm curious anyway... does anybody know what the cost would be to have some 30-spline half-shafts made up for our front end? I'm not even sure what the things would look like--I know the inner end would look like a regular axle stub, but what about the outer? There's no U-joint or anything; is it splined too, to accept the CV, or does it mate with a CV adapter or what?
Last edited by soksniffer; Nov 27, 2004 at 07:51 PM. Reason: clarity
Thread
Thread Starter
Forum
Replies
Last Post
95 bronco
1978 - 1996 Big Bronco
4
Jan 22, 2005 11:30 PM
569104
1999 - 2016 Super Duty
2
Mar 31, 2004 07:13 AM
