Has anybody here ever used them? JC Whitney and others sell these. You can get cab corners, wheel arches, etc. I too, have pin holes of rust forming above the rear wheel arches on my 95 F-150.

I had thought about using replacment panels here. But, I have only done stick welding. Do the panels need to be mig welded in place?

Do they look good when done properly? Do they hold up?

I would like your opinions.

Thanks.
Clava

1995 F-150 4x4 ext cab 5.8 E4OD 189,000 miles.

Have you driven a Ford lately?

 

i'd say stay away from JC Whitney if possible, they may be cheaper but so is their quality. go to someplace like NPD or LMC.

FORDS_FORLIFE

 

The replacement tailgate ($105) I got from JCW was a piece of cheap, weak crap!
The one bedside panel was also flimsy, so I returned it.

I did like the parts I got from Raybuck and Mill Supply