2.9 ignition control module

Reply Subscribe

Thread Tools

Search this Thread

Sep 7, 2004 | 05:40 PM

larryjw

Thread Starter

New User

Joined: Sep 2004

Posts: 4

Likes: 0

2.9 ignition control module

Im trying to repalce the ign. contrl. mod. on my 86 bronco II 2.9, as you know its a bear to get at and i dont know what type or size of tool I need for the screws and of course I cant see it. So if someone can just tell me what type of tool to use Id appreciate it

Thanks Larry

Sep 7, 2004 | 06:13 PM

Monty06

Posting Guru

Joined: Aug 2004

Posts: 1,167

Likes: 1

From: miami florida

module

go into any pepboys or autozone and ask for a ford module tool cost is like 5 bucks

Sep 7, 2004 | 07:19 PM

nijwnfi

5th Wheeling

Joined: Jul 2004

Posts: 38

Likes: 0

Also be careful with the screws when you remove them -easy to drop, hard to find. Removal tool is a must have makes it so much easier

Sep 8, 2004 | 07:59 AM

larryjw

Thread Starter

New User

Joined: Sep 2004

Posts: 4

Likes: 0

Ok I got the tool and replaced the module, of course it didnt solve the problem

Thanks for the help Larry

Sep 8, 2004 | 04:12 PM

nijwnfi

5th Wheeling

Joined: Jul 2004

Posts: 38

Likes: 0

What problem are you having? I'll all but guarantee someone here can help

Sep 8, 2004 | 07:33 PM

Ken00

Post Fiend

Joined: Dec 2001

Posts: 10,562

Likes: 4

From: South Jersey

The best place to start for most engine problems is pulling codes and testing fuel pressure.

Sep 11, 2004 | 10:46 PM

mueckster

Lead Driver

Joined: Jun 2003

Posts: 8,298

Likes: 25

From: Damon (South East Texas)

Are you sure it's the ignition? The stator assembly in the distributor could be bad. The early TFI igniton distr's were equipped with a rubber on the stator connector that would crack and short out the wire terminals. If the stator is good, you should get a test light to blink when probing the negative side of the coil when cranking.