Bronco overheating
Thread Starter
|
New User
Joined: May 2004
Posts: 4
Likes: 0
Bronco overheating
I put is a painless harness in my bronco and am now having overheating problems. I am only speculating that it is a wiring problem because the overheating started at around the same time I put in the new harness, but you know houw these things go! I have replaced the thourmistat, h2o pump, and radiator cap. On the origional harness I only had one wire that ran my Accell 300+, but now I have to use two. One of the wires starts it and the other keeps it running in the "run" position. Does any one out there know what the exact voltage the ingition wires for the Accell 300+ are supposed to recieve in the different ignition switch positions IE: start, and run. I also have a Malory unilite distributor, I would like the same info for it as well and any other sugestions that might help me get the bronco back on the road.
<!-- / message -->
<!-- / message -->
Thread
Thread Starter
Forum
Replies
Last Post
mythbustingpyro
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
15
Oct 26, 2013 08:36 AM
Micheal86
Clutch, Transmission, Differential, Axle & Transfer Case
0
Jan 20, 2011 02:59 PM
big4x4bronco
1987 - 1996 F150 & Larger F-Series Trucks
8
Nov 11, 2003 07:14 PM
Porco_dio
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
Sep 23, 2002 03:10 PM
