Control Arm/Torsion bar
Thread Starter
|
Posting Guru
Joined: Dec 2003
Posts: 1,951
Likes: 7
From: pacific northwest
Control Arm/Torsion bar
Needing to slide power steering rack through passenger side frame for removal. The lower control arm attachment at the chassis is preventing the rack from sliding far enough to remove. Would like to disconnect the lower control arm but note that there is pressure from the torsion bar. The front of the vehicle is being supported with jack stands at the driver lower control arm, passenger side of front crossmember and both sides of the frame just rearward of the front wheels.
The front wheels are off the vehicle and the passenger lower control are is hanging down unsupported. Like advice about disconnecting this lower control arm.
Thanks
Casey
The front wheels are off the vehicle and the passenger lower control are is hanging down unsupported. Like advice about disconnecting this lower control arm.
Thanks
Casey
Posting Guru
Joined: May 2003
Posts: 1,525
Likes: 3
It does look like the gearbox will not come out but if you rotate it back and forth you can remove it without removing any other parts. It has to come out on the drivers side.
Last edited by rclarke; Jan 1, 2004 at 04:47 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jniolon
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
Oct 24, 2015 09:01 AM
56-BW
1948 - 1956 F1, F100 & Larger F-Series Trucks
3
Jul 31, 2015 11:26 AM
cshuck01
1948 - 1956 F1, F100 & Larger F-Series Trucks
0
Jun 9, 2015 06:53 PM
slbeck1
Explorer, Sport Trac, Mountaineer & Aviator
3
Mar 10, 2008 09:40 PM
