I am trying to replace the rear seal on my transfer case right now. It is a NP208 on a 81 bronco. The seal that the yoke goes into. I droped the other side of the drive line but dont know how to get the yoke side out to get to the seal. Thanks for helping, i need to get this done pretty quick.

 

Ok i got the yoke out, any precautions on how to put the new seal in?

 

When i look at the bearings behind the seal the bearing retainer got pushed back. Should i try to take off the part of the housing
so that i may be able to get the retainer back on? Please help.

 

ok, i fixed the bearing problem, how about putting the seal in?