Ford L8000 rear engine mounts
Thread Starter
|
5th Wheeling
Joined: Sep 2020
Posts: 26
Likes: 0
Ford L8000 rear engine mounts
I’m looking for the rear engine frame mounts for a 1986-1990 Ford l8000 with a Cat 3208T engine. My bell housing is aluminum and has the round dowels on it. I need the frame mounts that the dowels sit in or if no one has these would anyone know the part numbers. These are Ford parts. I’ve called several salvage yards and they probably have them , but they need a part number . Thanks
Cargo Master
Joined: Dec 2015
Posts: 2,549
Likes: 331
From: Harned, Ky
Have you broke one ?
I’ve messed with those trucks for years and don’s remember ever replacing the frame bracket part of the mount, only on a couple occasions did we replace the rubber bushings while the engine was out
I’ve messed with those trucks for years and don’s remember ever replacing the frame bracket part of the mount, only on a couple occasions did we replace the rubber bushings while the engine was out
Thread Starter
|
5th Wheeling
Joined: Sep 2020
Posts: 26
Likes: 0
No, it had a Cummins in it that broke the crankshaft. I found a 1987 Ford C8000 firetruck with a 3208t in it with 11,000 miles on it very cheap so I put that in it. It had the same type rear mounts on the frame but they were to tall so I dropped them as low as I could and set the motor in. They are still too tall and is making my drive shaft angle too steep. They are aluminum so I figured it would be better to find the original ones for a 3208.
Thread
Thread Starter
Forum
Replies
Last Post
Red Rascal
1948 - 1956 F1, F100 & Larger F-Series Trucks
2
Nov 29, 2017 12:17 PM
