hello from north Florida
#1
The following users liked this post:
#2
Join Date: Dec 2003
Location: Saskatoon, Saskatchewan
Posts: 89,722
Received 1,357 Likes
on
1,116 Posts
Welcome aboard. Don't forget to drop by the local FL chapter too:
https://www.ford-trucks.com/forums/forum116/
https://www.ford-trucks.com/forums/forum116/
The following 2 users liked this post by Fomoko1:
#3
The following users liked this post:
#4
screws
oh man , thats an aluminum sheet i had that i cut out , i made some 1/4 " aluminum bushings to raise the emblem slighlty , and im using stainless steel hardware re purposed off some boat parts
The following users liked this post:
#5
I'm thinking: What if those screws are held on with little nuts on the other side of the lid? . . . and what if those nuts fall off in there and get sucked into the engine?
Thread
Thread Starter
Forum
Replies
Last Post