hello from north Florida
 

believe it or not this is the first ford ive owned and i only wish everyone knew about this solid American truck
https://cimg0.ibsrv.net/gimg/www.for...fb9231fedc.jpg
https://cimg2.ibsrv.net/gimg/www.for...82fe9439b8.jpg
https://cimg2.ibsrv.net/gimg/www.for...ceb1a6253b.jpg
https://cimg0.ibsrv.net/gimg/www.for...cebce69246.jpg
https://cimg5.ibsrv.net/gimg/www.for...8dd12c729c.jpg

Welcome aboard. Don't forget to drop by the local FL chapter too:
https://www.ford-trucks.com/forums/forum116/

Looks like a good one!

Be sure that the screws for the chrome logo don't have anything that can get sucked into the carburetor on the other side of the air cleaner lid:

https://cimg8.ibsrv.net/gimg/www.for...9af95ccd84.png

screws
 

oh man , thats an aluminum sheet i had that i cut out , i made some 1/4 " aluminum bushings to raise the emblem slighlty , and im using stainless steel hardware re purposed off some boat parts

I'm thinking: What if those screws are held on with little nuts on the other side of the lid? . . . and what if those nuts fall off in there and get sucked into the engine?