release bearing spring
Fleet Owner
Joined: Jul 2004
Posts: 27,288
Likes: 1,052
From: NM
What do you mean by "pulled into the housing"? Is it actually coming off at one end?
Did you have the flywheel machined? If it has been machined a couple of times, the whole clutch assembly may be too far forward now. But I still wouldn't think the spring would be stretched excessively.
Did you have the flywheel machined? If it has been machined a couple of times, the whole clutch assembly may be too far forward now. But I still wouldn't think the spring would be stretched excessively.
Thread
Thread Starter
Forum
Replies
Last Post
ihf-350
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
8
Jul 29, 2015 12:38 PM
OldWoodsDiesel
1994.5 - 1997 7.3L Power Stroke Diesel
5
Aug 31, 2013 07:50 AM
kinderjw
Clutch, Transmission, Differential, Axle & Transfer Case
10
Jul 22, 2004 04:45 PM
