For those who might want to know how to install the windshield washer kit "See Clear" SK-TAAH-17503-A.
Came from Ford Motor Company Dearborn, Michigan.

 

Excellent resource! Thanks for posting.
Regards, Mark.

 

That's cool! I have a hood that has the squirter in it I got off a grain truck, wish I had the whole set up.

 

Thats cool, I like they tell you exactly where to drill and mount everything and then wind the hose like a snake and tell you to cut to length.

 

That is cool to have. I have a copy of the 53-55 Windshield Washer Installation instructions. I copied this off an ebay auction and printed it out. I have this style washer in my 55 F350. The bottle, hoses and inside bottle stuff were missing. Replaced them with Mid-Fifty products.



Here is a similar paper I found in the glove box of my 55 when I got it home in 2016. It shows how the heater hoses should be placed when dealers installed the extra cost heater.

Full sheet

close up of Big Job engines routing

Close up of 6 cylinder routing

Close up of 239 V-8 routing

 

Does anyone have one of these windshield washer set up on their 1956 F100? I am trying to figure out the mounting hole for the pump on my 1956 F100 and the instructions are not clear. I see that it is 3.12" to the right of the centerline of the wiring harness hole on the firewall and 1.4" down from a horizontal line but there is no reference to exactly where that horizontal line is located. I was hoping for some better measurements. Thank you!