E4od won't go into gear
Thread Starter
|
Senior User
Joined: Dec 2013
Posts: 115
Likes: 0
From: Lockport
E4od won't go into gear
Hello everyone,
I have a 95 f250 with about 210k on her. 4wd. Trans was rebuilt at 180. I was driving it home one day on the highway doing about 65. It felt like it slipped into neutral, let off the pedal. Popped back into gear. Never did it again. A few days later I moved my car trailer, backed it into my neighbors drive. I just started rolling back. Went onto neutral. Never came back.
Fluid level is good. Ohmed out solenoids 1 and 2 came in at 19.8. the clutch solenoid was also at 19.8.
I put 12v to them and I could hear them click. 1 seemed quiter than the others. Maybe of locatiolocation?
I replaced the gear position sensor on the driver side.
I have a 95 f250 with about 210k on her. 4wd. Trans was rebuilt at 180. I was driving it home one day on the highway doing about 65. It felt like it slipped into neutral, let off the pedal. Popped back into gear. Never did it again. A few days later I moved my car trailer, backed it into my neighbors drive. I just started rolling back. Went onto neutral. Never came back.
Fluid level is good. Ohmed out solenoids 1 and 2 came in at 19.8. the clutch solenoid was also at 19.8.
I put 12v to them and I could hear them click. 1 seemed quiter than the others. Maybe of locatiolocation?
I replaced the gear position sensor on the driver side.
Thread
Thread Starter
Forum
Replies
Last Post
Rickerho1
1987 - 1996 F150 & Larger F-Series Trucks
18
Jun 25, 2019 01:16 PM
ExcellentRed
Clutch, Transmission, Differential, Axle & Transfer Case
2
Jul 5, 2003 05:22 PM
