shifter boot & bezel replacement
Thread Starter
|
New User
Joined: Sep 2020
Posts: 1
Likes: 0
shifter boot & bezel replacement
1995 Ford F150 manual trans M5OD-R2 - trying to replace the shift boot and bezel. How do I do that. The shift lever appears to be two piece and should come apart so that I can replace the bezel that is on the floor and the shift boot. Hole on bezel is not big enough to go over shift lever. Pulling my hair out.
Cargo Master
Joined: Jan 2004
Posts: 3,118
Likes: 149
From: South Dakota
There is a bolt near the bottom of the shift lever that has threads on both ends. Take the nut off and put it on the threads on the other end and tighten the nut to remove the double sided bolt holding the shift lever on.
Laughing Gas
Joined: Oct 2018
Posts: 1,011
Likes: 87
From: San Diego
after removing shift lever, lube the hole with dish soap, and stretch rubber boot over the shift lever. It will be difficult, but can be done.
I did same job less than 2 years ago.
I did same job less than 2 years ago.
Last edited by marksman76; Sep 27, 2020 at 08:08 PM. Reason: extra word
Thread
Thread Starter
Forum
Replies
Last Post
