Water temp open loop
Thread Starter
|
New User
Joined: Aug 2019
Posts: 10
Likes: 0
Water temp open loop
Hey guys. is there anyway I can get my water temp sender to send a closed loop to the ecm before it hit the 160 mark? working with an altered 1993 to 1995 project. just looking to see if the MAF is good. Or is there an OHM I can check at the Maf of a 1995 to test if its good? Haven't got this thing to run right, but been working on it for weeks... Fuel filter, fuel line flush, battery, alt, checked wiring, etc...
TIA
TIA
Fleet Owner
Joined: Oct 2005
Posts: 20,789
Likes: 1,753
From: Kentucky
The Engine Coolant Temperature (ECT) sensor does not "send" a closed loop signal to the computer. The computer monitors the ECT signal then turns on closed loop operation based on it's programming. ECT is analog device.
What issues are you having?
What issues are you having?
Lead Driver
Joined: Jan 2019
Posts: 5,081
Likes: 865
From: N.W. Alabama
if it runs, have you checked for codes?
Part 1 -How to Test the Ford Mass Air Flow (MAF) Sensor
Part 1 -How to Test the Ford Mass Air Flow (MAF) Sensor
Thread
Thread Starter
Forum
Replies
Last Post
