ingnition removal
Senior User
Joined: Mar 2003
Posts: 302
Likes: 0
From: Cincinnati, Ohio
Remove the steering wheel. Turn the ignition to the acc. position.
Inside the steering column you will see a small pin hole next to the ignition lock. Press the ball in the pin hole while pulling on the key.
zanny
Inside the steering column you will see a small pin hole next to the ignition lock. Press the ball in the pin hole while pulling on the key.
zanny
Posting Guru
Joined: Jun 2001
Posts: 1,208
Likes: 0
From: Conyers
Are you talking about the ignition switch or the lock cylinder? (the thing you put the key into) Either way you don't have to remove the steering wheel. To replace the ignition switch, remove the 4 bolts that hold the steering column up. Unplug the connector and remove the two bolts and note where the switch is lined up. Put the new switch in place and then bolt it on and plug in the connector. It may take some fine tuning to get it like it's supposed to be, but it's no big deal. Bolt the steering column back up and bam, your done.
Elder User
Joined: Oct 2002
Posts: 834
Likes: 0
From: Germany
