Had a model axal that was bent, had it straighten I thing you could take it to a large truck shop

 

That's a good idea! Find a big rig truck shop and ask to see if they can straighten it out. Might be cheaper than shipping.

 

I tried to PM you as well, but couldn't figure it out. Definitely let me know. I live in a smaller town and will probably have to drive a couple hours to get to a shop that deals with big trucks/ bends axles

 

I figured out how to send a private message but got this. Check your settings in your profile.

 

I checked the settings and didn't see anything about enabling pm's. Maybe it's because I'm new and have to reach a certain post count before it's enabled?

 

You must have clicked on the right thing because I was able to send you a message.
I had a pair of fenders shipped to me from Oregon to Dallas via YRC freight. Look them up and see if they're near by.
Message me back with your address and I'll see what shipping estimate will be. I have the extra axle stored away at my parents place but will be going there this weekend.

 

I'll look them up. This is the one I picked up a few weekends ago.



The old axle on the left for comparison. It's a lot straighter.

You can see it's still a little off


New on left, old on right.

 

When I take run out to go get the axle tomorrow, I'll check to see if its straight as how you show in the pics.

 

Thanks! I appreciate it