pulling codes from a '96 (10/95) ????????
Thread Starter
|
New User
Joined: May 2001
Posts: 8
Likes: 0
pulling codes from a '96 (10/95) ????????
[font size="1" color="#FF0000"]LAST EDITED ON 09-Jun-01 AT 07:06 AM (EST)[/font][p]any way to get the codes out without a scanner? I have an F150 5.9L, 1996, (built in 10/95). The darn check engine light is on. Truck runs fine.
TIA
PS, my data connector has pins 2,4,5,10,13,16 OBDII ?
TIA
PS, my data connector has pins 2,4,5,10,13,16 OBDII ?
Senior User
Joined: Feb 2000
Posts: 369
Likes: 1
pulling codes from a '96 (10/95) ????????
A Haynes Manual has the procedure for checking the codes with a voltmeter. Just count the pulses like morse code. Not hard, but you'll need someone to push in the clutch if it's a manual.
