Good afternoon all - I am a member of the Bronco forums and recently found this forum as well.

I am currently doing a frame off, nut and bolt, restomod of a 74 Bronco and will post some photos in my profile in the near future. I am in the assembly stage and currently installing the new wiring harness on the dash and front end.

My next project is a 77 which is sitting in the garage waiting for me to get some time (once the 74 is finished). It is pretty much all original sheet metal, motor and tranny with 48k original miles. It will still get lifted from the frame but not quite as extensive of a project as the 74. Photos to be posted soon.

I also have a 1968 Grumman Olsen that I am looking for a little assistance with. The headlamp bezels are plastic and the drivers side has deteriorated to the point that I need to replace it, I think earlier (50's - early 60's were aluminum which I would prefer). The passenger side is in ok condition and I am looking to replace it as well and/or use it as a template or mold for the drivers side. I have contacted a 3D printing company and it is out of my league. I would hope that someone will read this post and know someone who has a set, has the fabrication skills, or knows someone that can assist me.

Any info would be great!



This is the drivers side that needs immediate attention.


This is the passenger side that could be the template or mold for the new ones.

Thanks, Kevin

 

Welcome to the FTE Forum irishjig13

All I can say is...POST PICTURES !