I am new to this site so go easy on me if this has been a question that has been asked alot. Here are my thoughts-- I know
that some poeple say to use a 2" spacer but if I am ordering a 2" spacer for a 2000 F250 then both sides will have the same
diameter centric parts so then it would match the 2000 but not the 2016 rim and vise versa if I ordered it the other way.
Can someone please let me know if they have ran into this and what I can do? Or should I just get rid of them and buy the
correct tires/rims? Thanks

 

I'm not a big fan of those spacers. I know a lot of people in the off road community use them with good results.

Unless you are dead set on those rims I would rather sell them and get the correct ones.

Figure value of the 2016 rims and what the spacers cost vs new correct rims and I bet its a wash.

 

Thank you very much for the reply. I was leaning towards just selling them and trying to get my money back. Then just
purchase new tires to go on the rims that I have.. I dont want to put alot in it My old truck is getting tired 518k miles on
her lol. Again thank you for the input.