Goodnight Rick... TTYL

I was going to do the same thing

 

Good morning and have a fantastic Friday Illinois

 

Good morning Illinois

 

Good evening Illinois, Jim, and John!

Was another nasty assed day here. If we don't get outside by 10:00AM you might as well stay inside. Was 87° at 7:30 this morning. The heat index for today was 114°.

 

Hello Rick, wasn't comfortable working on the truck this morning so waited until this afternoon, didn't get as much done as I should have

 

Are you pulling the tranny?

 

I pulled the exhaust and cross members today , just have a couple bolts to remove and lower the transmission tomorrow and slide the other in place tomorrow and start putting it all back together and measure up for a drive shaft and order it..

 

How long does it take to get a drive shaft made?

 

Last one was only 2 days but maybe depends how busy they are..that was shipped from Winnipeg..

 

Maybe you'll be driving it again in a week, bar no problems.

 

I hope by the end of next week, should have most of it put back together tomorrow hopefully..

 

Hopefully you won't have any problems that slow you down. I know you're excited to get to driving it again.

 

I'd like to take it to the next show but have the panel as a back up..would like to get all the bugs out of this one though...

 

You have taken it on some long drives, this is good. Problems will show up, you'll go home and fix it and try again. I think its gotten to the point that you can trust it. Now you have to go through the process with the tranny.

 

Goodnight John TTYL bud.