1999 F450 gear swap question
#1
1999 F450 gear swap question
I have a 1999 F450 with a 6.8L and auto trans. The gear ratio is 4.88 and those puppies are geared LOOOOW.
Has anyone swapped ring and pinions on these (or anything close)? Factory options I think were 4.88, 4.56, 4.30, 4.10 and 3.73's in some 350s SRWs and 250s
And to clarify, would I be correct that the rear is is a Dana 80 and the front a Dana 60?
I just want to make this big fella a little longer legged and a leeeetle less hard on fuel
Input: GREATLY APPRECIATED
Has anyone swapped ring and pinions on these (or anything close)? Factory options I think were 4.88, 4.56, 4.30, 4.10 and 3.73's in some 350s SRWs and 250s
And to clarify, would I be correct that the rear is is a Dana 80 and the front a Dana 60?
I just want to make this big fella a little longer legged and a leeeetle less hard on fuel
Input: GREATLY APPRECIATED
Thread
Thread Starter
Forum
Replies
Last Post
SoCal69
Clutch, Transmission, Differential, Axle & Transfer Case
0
06-20-2018 01:55 AM
Outlaw56
1948 - 1956 F1, F100 & Larger F-Series Trucks
2
06-10-2013 05:31 PM
klatt_89
Clutch, Transmission, Differential, Axle & Transfer Case
11
01-14-2006 07:05 AM
turjam_01
1948 - 1956 F1, F100 & Larger F-Series Trucks
10
01-05-2003 09:58 AM