I'm looking for measurements of the 300 6 from the rear block face to the end of the water pump pulley. Both v belt and serpentine belt setup measurements. I need measurements without the fan please. My Google searches keep giving me vague guesstimates.

 

This was copied from the Fordsix Performance Forum...



300 I6 dimensions
<table width="100%" class="bb-table" border="0" cellspacing="0" cellpadding="0"><tbody><tr><td width="4" height="4" class="bb-left-top"></td><td width="100%" class="bb-top"></td><td width="4" height="4" class="bb-right-top"></td></tr><tr><td class="bb-left"></td><td width="100%" class="bb-content bb-quote">THE FRENCHTOWN FLYER wrote:
300's weigh about 490 pounds.

300 DIMENSIONS (1971 year):
FRT-FACE-OF-BLOCK to REAR-FACE-OF-BLOCK: 725 mm / 28.56"
OAL (FAN-to-CRANK-FLANGE): 931 mm / 36.65"
HEIGHT CL CRANK-to-TOP-OF-BREATHER-CAP: 486 mm / 19.12"
HT OIL-PAN-to-TOP-OF BREATHER-CAP: 690 mm / 27.17"
Sorry, no motor mount dims.

</td><td class="bb-right"></td></tr><tr><td width="4" height="4" class="bb-left-bot"></td><td width="100%" class="bb-bot"></td><td width="4" height="4" class="bb-right-bot"></td></tr></tbody></table>

thread

Other useful 300 stats:

Deck Height: 10.000
Crank Throw: 1.990
Rod Length: 6.2097
Compression Height: 1.757
Deck Clearance: 0.0433

also:
Height of EFI intake from the top of the head: approx 8 5/16ths"
however, the IAC Valve is a good 1 1/8th" above that

these numbers might be off up to 1/4 inch
thread

_________________
Right and Wrong are just words, what matters is what you do

Susie - a work in progress
Clyde - ya mule!


Last edited by Asa on Wed Jan 16, 2008 10:57 pm, edited 1 time in total.

 

Any idea what it would be without the fan on it? And where exactly does the crank flange lie in relation to the bell housing face?