Mistake
Thread Starter
|
New User
Joined: Feb 2016
Posts: 11
Likes: 0
Mistake
So I've been rebuilding an 84 f250, I sanded the cab down to bare metal and painted it. My issue is I used an industrial enamel that just dosent look good at all. The damn stuff clumps up and clogs sandpaper quite quick. Tips on getting that crap off?
Fleet Owner
Joined: Aug 2010
Posts: 21,253
Likes: 1,656
From: Reynoldsburg, Ohio
I'd use some sort of chemical stripper to get the bulk of it off. I'm thinking if it were fully cured sanding it off would be "easy"---if still a bit fresh that might be why its clumping and clogging.
Most industrial enamels aren't well suited to automotive finishing---two very different uses and environments they'll experience.
Most industrial enamels aren't well suited to automotive finishing---two very different uses and environments they'll experience.
Thread
Thread Starter
Forum
Replies
Last Post
Stephen67
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
Jun 19, 2012 11:36 PM
r_reed
1948 - 1956 F1, F100 & Larger F-Series Trucks
17
Apr 10, 2011 09:43 AM
