Propane usage
Steve
Normally, you select the tank you want to use. There is an arrow on the value that points to the tank you are using. When both tanks are open, using the **** on top of the tank, when one tank is open, the regulator automatically switches to the other tank and your indicator on the regulator will go to red. All regulators have some kind of indicator.
When it is red, you switch the valve to the full tank and you can now remove the empty tank to take it to be filled. The regulator should stop propane from flowing through the open hose when you remove the tank. If you want to use only one tank, shut the other one off. This is just preference, there is not right or wrong way!
A caveat- that is how it is supposed to work. What you may discover is that the regulator does not completely stop the flow of propane through the disconnected hose, when you remove a tank. This is really a common issue and something that folks often miss. It is easy to detect. When you pull the tank and have your regulator set on the full tank, just listen at the end of the disconnected hose. If you hear a hiss, this means your regulator is not working properly and the regulator should be replaced. Do not panic, just turn off the full tank using the **** on the top.
When installing a new regulator, the hoses that connect to it really require a good deal of torque to completely seal. The ends are brass so the biggest wrench in the tool box is probably a bad idea (
), but be sure to check with soapy water or bubble leak detector when you are done. To check you entire system for propane leaks, open a tank and select it with your regulator so your indicator goes green. Now shut off the tank. If your system is completely sealed, your regulator will continue to show green. If after a few minutes it goes back to red, your system is losing pressure. Unless someone has worked on your system recently, the leak is nearly always at the regulator or hoses (I have had new hoses leak at the brass where it is crimped into the hose, so do not assume new means good).
When regulators fail, they fail to the low side meaning reduced pressure at appliances. This is very easy to tell by just looking at the flame on your cooktop, a weak flame normally means low pressure. Yes, it is possible to adjust some regulators, but in my experience, when that is necessary, the regulator is shot.

Steve
Normally, you select the tank you want to use. There is an arrow on the value that points to the tank you are using. When both tanks are open, using the **** on top of the tank, when one tank is open, the regulator automatically switches to the other tank and your indicator on the regulator will go to red. All regulators have some kind of indicator.
When it is red, you switch the valve to the full tank and you can now remove the empty tank to take it to be filled. The regulator should stop propane from flowing through the open hose when you remove the tank. If you want to use only one tank, shut the other one off. This is just preference, there is not right or wrong way!
A caveat- that is how it is supposed to work. What you may discover is that the regulator does not completely stop the flow of propane through the disconnected hose, when you remove a tank. This is really a common issue and something that folks often miss. It is easy to detect. When you pull the tank and have your regulator set on the full tank, just listen at the end of the disconnected hose. If you hear a hiss, this means your regulator is not working properly and the regulator should be replaced. Do not panic, just turn off the full tank using the **** on the top.
When installing a new regulator, the hoses that connect to it really require a good deal of torque to completely seal. The ends are brass so the biggest wrench in the tool box is probably a bad idea (
), but be sure to check with soapy water or bubble leak detector when you are done. To check you entire system for propane leaks, open a tank and select it with your regulator so your indicator goes green. Now shut off the tank. If your system is completely sealed, your regulator will continue to show green. If after a few minutes it goes back to red, your system is losing pressure. Unless someone has worked on your system recently, the leak is nearly always at the regulator or hoses (I have had new hoses leak at the brass where it is crimped into the hose, so do not assume new means good).
When regulators fail, they fail to the low side meaning reduced pressure at appliances. This is very easy to tell by just looking at the flame on your cooktop, a weak flame normally means low pressure. Yes, it is possible to adjust some regulators, but in my experience, when that is necessary, the regulator is shot.

Steve
Valve was showing red on one tank which by lift was clearly empty. So I manually switched the valve to point toward the full tank and my old flame came back and fridge worked.
A stop at Camping world confirmed it was prob a bad valve, but was a 3 day wait to get one installed, even then it had to be by appt. I live an hour+ away and the Tech was a good guy and said if you have basic tools this is an easy fix, he pointed, I bought a new valve, installed it and that was 3 years ago.
I did forget to mention all RVs require working propane leak detectors according to code. A leak detector will squeak due to a leak long before anyone will ever smell propane. The one I carry on my truck will actually smell propane through a closed door before anyone inside will ever smell it! Be safe!
I did forget to mention all RVs require working propane leak detectors according to code. A leak detector will squeak due to a leak long before anyone will ever smell propane. The one I carry on my truck will actually smell propane through a closed door before anyone inside will ever smell it! Be safe!
I do not know how many locations it added, but the 'odorizer' here in Texas that I know of is South of Dallas about 60 miles or so. Its way off the road and the stench is so strong you have to wear a gas mask.
Mercaptan is so powerful it can be detected in as little as 1 part per million!
People who have eaten asparagus can experience the distinctive smell of mercaptan in their urine within 30 minutes of consuming the vegetable. However, not everyone is able to smell mercaptan in their urine as a genetic mutation in some people means they are immune to the odor.
Stewart
Ford Trucks for Ford Truck Enthusiasts
A buddy who has 20# tanks has been burning through them................but he's been starting his fridge on propane 2 days before every trip. He said someone told him he couldn't run the fridge off a 15 amp service. He's been corrected and will save some propane now!
Modern RV's for the most part have leak detectors that will automatically shut the flow off if there is a leak or an underside hose or pipe is comprised.
There is a safety system built into all tank valves that stops the flow of propane if a line breaks, but it does not completely stop it, just slows it down greatly. It does not generally engage unless the breach is fairly large. You can test this by simply turning on the cooktop without lighting it until the detector squeals (though I do not recommend this). You will see that the propane continues to flow.
The refrigerator manufacturers feel it is safe to operate the fridge while underway. If you want to be 100% safe, some would argue the tanks should be shut off before leaving the campground or your house. But, that leads one to argue if you want to be 100% safe you should never leave home!
Like so many things in life, this is a judgement call.

Steve
.
Again, this is a judgement call.

Steve
Lost no propane that I could tell. In the pic I just put tape over the connection, changed the tire and went home the rest of the way.











