Drilled / slotted rotors?
Thread Starter
|
Senior User
Joined: Feb 2004
Posts: 136
Likes: 0
From: Harpers Ferry WV
Drilled / slotted rotors?
I have a new set of drilled / slotted rotors. If the venting vanes are not angled can the rotors go on either side or is there a correct direction of rotation?
Thread Starter
|
Senior User
Joined: Feb 2004
Posts: 136
Likes: 0
From: Harpers Ferry WV
Prime Choice drilled / slotted rotors. My RR caliper stuck a few days ago, ate the pads down to the backing plate and wasted the rotor. The boxes are labeled R and L but the direction of the slots/ holes are opposite of the last set I got from the same company last fall.
I did a lot of research on the 'net last night. It appears the only thing that really matters as far as direction goes, is if the vanes are angled. These rotors have straight vanes. I shot Prime Choice an email and will post their response (if I get one).
I did a lot of research on the 'net last night. It appears the only thing that really matters as far as direction goes, is if the vanes are angled. These rotors have straight vanes. I shot Prime Choice an email and will post their response (if I get one).
Thread
Thread Starter
Forum
Replies
Last Post
davidsca
Brakes, Steering, Suspension, Tires, & Wheels
2
May 13, 2006 11:23 PM
