Tie rods
Thread Starter
|
Posting Guru
Joined: Nov 2008
Posts: 1,229
Likes: 2
From: Oregon
Tie rods
99 F-250 SD V-10 2 WD
I have the parts and may have to have it done, in 2 steps.
If I do the tie rods first, do they have to come back off, to do the ball joints?
And can I pre-assemble the tie rods, before installing? At least, in 2 sections?
Is this truck twin I-beam, or the other type?
I have the parts and may have to have it done, in 2 steps.
If I do the tie rods first, do they have to come back off, to do the ball joints?
And can I pre-assemble the tie rods, before installing? At least, in 2 sections?
Is this truck twin I-beam, or the other type?
New User
Joined: May 2015
Posts: 19
Likes: 0
From: London Ontario Canada
im currently doing ball joints on my 2000 Ex and yes the tie rods have to come off the knuckle so when they are un done the whole thing drops out and its easier to get the hub nuts of the back with the tie rods off. its a bitch to do though
oops my bad you have a 2wd with no knuckles but i bet it will still be easier
oops my bad you have a 2wd with no knuckles but i bet it will still be easier
Thread
Thread Starter
Forum
Replies
Last Post
