Large external Dana 44HD hubs on 78/79 high pinion 44?
#1
Large external Dana 44HD hubs on 78/79 high pinion 44?
This might be an odd question, but does anyone know if it's possible to put the large external hubs from a Dana 44HD onto a later high pinion Dana 44?
I have a low pinion Dana 44HD axle out of a 76/77 Highboy and a high pinion Dana 44 out of a 1978 F250...both have ball joints and disc brakes. At first glance it looks like I could swap out everything from the steering knuckles out (knuckles, spindles, bearings, hubs, etc.).
Anyone know if this can be done?
I have a low pinion Dana 44HD axle out of a 76/77 Highboy and a high pinion Dana 44 out of a 1978 F250...both have ball joints and disc brakes. At first glance it looks like I could swap out everything from the steering knuckles out (knuckles, spindles, bearings, hubs, etc.).
Anyone know if this can be done?
#2
I've been doing some research on other off-road forums and I think it can be done. Sounds like guys are using the 44HD parts (from the knuckles out) to upgrade the high pinion Dana 44 1/2 ton axles to the 8 lug hubs.
Would still be interested to hear from anyone who has done this (or seen it done).
Would still be interested to hear from anyone who has done this (or seen it done).
#3
Thread
Thread Starter
Forum
Replies
Last Post
hail destroyer
1973 - 1979 F-100 & Larger F-Series Trucks
10
12-21-2017 10:59 AM
1972RedNeck
1973 - 1979 F-100 & Larger F-Series Trucks
5
01-27-2013 06:56 PM
David85
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
24
01-02-2010 01:53 AM