Bought a lund visor!
Thread Starter
|
Laughing Gas
Joined: Jan 2011
Posts: 763
Likes: 19
From: MA
Bought a lund visor!
Ended up getting a lund visor for 40$! I always see mixed thoughts about them but I think they look really cool on the Ford brick noses. I've never installed one so I wanted to see what anyone that has installed one has to say. I've read that you need to use sealant around the hole that will be drilled and basically in the holes to prevent leaking. Anything else that I should be aware of?
Freshman User
Joined: Dec 2014
Posts: 26
Likes: 0
Installed a couple before. Take your time pre drilling holes and measure everything 3 times. If you don't instal it just right and it doesn't sit solid, it will eventually wear and weaken the holes and the only real option is welding them up. I learned this the hard way.
Moderator & parts slinger
Joined: Feb 2007
Posts: 50,157
Likes: 5,786
From: S/W Missouri, Polk county
X3 on measure 3 times drill once.
Use stainless steel hardware.
Use plenty of sealant, on both sides of the hdwr.
Because those visors can be a rust magnet for the A pillar and fwd cab door hinge area...
Use stainless steel hardware.
Use plenty of sealant, on both sides of the hdwr.
Because those visors can be a rust magnet for the A pillar and fwd cab door hinge area...
Thread
Thread Starter
Forum
Replies
Last Post
svooom
1948 - 1956 F1, F100 & Larger F-Series Trucks
14
Jun 18, 2005 12:01 PM
