Yblock crank bolt size?
Thread Starter
|
New User
Joined: Aug 2014
Posts: 2
Likes: 0
Yblock crank bolt size?
Hi fellas,
I'm working on the 292 yblock engine off my 63 f100. I removed the crank pulley bolt, only to find out it was stripped on the lower 1/2" end of the bolt. Now I'd like to run a tap just to clean up the threads that were boogered, but I need to know what size tap to purchase. Would you guys know what size I need?
Also, I'd need to buy a new crank pulley bolt. Any ideas on where to get a new one?
Much appreciated,
George
I'm working on the 292 yblock engine off my 63 f100. I removed the crank pulley bolt, only to find out it was stripped on the lower 1/2" end of the bolt. Now I'd like to run a tap just to clean up the threads that were boogered, but I need to know what size tap to purchase. Would you guys know what size I need?
Also, I'd need to buy a new crank pulley bolt. Any ideas on where to get a new one?
Much appreciated,
George
Thread
Thread Starter
Forum
Replies
Last Post
johnnydmetal
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
2
Nov 26, 2008 05:35 AM
Payner44
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
3
Feb 15, 2008 06:35 AM
Silver Streak
Ford Inline Six, 200, 250, 4.9L / 300
2
Mar 18, 2005 03:05 PM
