300 ring type
Cargo Master
Joined: Mar 2008
Posts: 2,569
Likes: 207
From: Washington
The rings sealed up fine and got rid of my excessive blow by problem. 5 out of 6 top piston rings were broken.
I would use felpro 525SD head gasket an the newer one piece oil pan gasket.
It is kinda freaky ... but it doesn't leak a drop of oil and goes 3500-4000 between oil changes without added any oil, It was using a qt every 800 miles. Best $100 I ever spent on the truck.
Jim
.
Cargo Master
Joined: Mar 2014
Posts: 2,031
Likes: 72
I used cast on my $100 engine in truck overhaul. They will be more likely to break-in in a used bore. I did not even run a hone through it, just rings and rod bearing.
The rings sealed up fine and got rid of my excessive blow by problem. 5 out of 6 top piston rings were broken.
I would use felpro 525SD head gasket an the newer one piece oil pan gasket.
It is kinda freaky ... but it doesn't leak a drop of oil and goes 3500-4000 between oil changes without added any oil, It was using a qt every 800 miles. Best $100 I ever spent on the truck.
Jim
.
The rings sealed up fine and got rid of my excessive blow by problem. 5 out of 6 top piston rings were broken.
I would use felpro 525SD head gasket an the newer one piece oil pan gasket.
It is kinda freaky ... but it doesn't leak a drop of oil and goes 3500-4000 between oil changes without added any oil, It was using a qt every 800 miles. Best $100 I ever spent on the truck.
Jim
.
Mine leaks along with what I believe to be the rear main. Not delving into the engine any time soon, but interested in what it takes to replace the oil pan gasket.
New User
Joined: Jun 2014
Posts: 21
Likes: 0
Pan gasket isnt to bad had to pull radiator, starter, lifted off of the exhaust bolt and front valve cover bolt, but I wouldn't use the valve cover bolt again kinda sketchy. If it has a standard watch the clutch bar that runs from frame to motor and it will give more room if u pull valve cover.
Thread
Thread Starter
Forum
Replies
Last Post
rustoleum82
Ford Inline Six, 200, 250, 4.9L / 300
1
Apr 22, 2015 07:34 PM
sh3d3vilinme
Ford Inline Six, 200, 250, 4.9L / 300
8
May 17, 2006 10:53 AM
scounts_iii
Ford Inline Six, 200, 250, 4.9L / 300
8
Nov 1, 2004 02:28 AM
