Does anyone have any photos of fenderwell headers on their 2wd? I have done the CV swap on my 77' and will be going back with a 460/c6. I have found several sets of headers and its looking like the L&L 3/4 length headers are going to be my best bet. I would love to go with a full length set but they all seem to run so low, I don't want them hanging down that far with this front suspension swap. I have a feeling the fenderwell exit will interfere with the steering shaft and possibly the upper crossmember mount, but I havent been able to find any installed pictures of them in a 2wd. These are the one I have been looking at 460 Fenderwell Exit 2 Wheel Drive Only

 

Both have great reputations

Stan's headers 2wd 460
248Y

Maddog headers - F150-250 2WD 1966-79
Part #9230 - 429/460 engine, 2" primaries, 3 1/2" collectors, fits with power steering, fenderwell exit.

 

I was looking at the maddog's and the photo looked the same as the ones from JBG. Just not sure how the fit will be since I haven't been able to find an installed photo.

 

How low can you go .. 460 with sanderson's The Sanderson FF460 header set is designed to fit 1935-40 cars and trucks using Ford Big Block 429-460 engines.

http://www.american-monsters.com/195...on-experience/