stub shaft to knuckle free play
#1
stub shaft to knuckle free play
Just wondering how much free play I should be getting at the stub shaft? I put a new wheel speed sensor in today and was poking around trying to find a clunk (confirmed end link bad) but while I was in there I grabbed the front axle u-joints and there seemed to be a bit of play where the stub shaft goes into the knuckle. I have manual hubs so I am not real worried about it creating vac leaks etc. The bearing itself feels great so I don't think it is bad, just didn't know how much movement was acceptable. I have brand new hub locks installed so it isn't slop in the hub either. Any thoughts would be great
Thread
Thread Starter
Forum
Replies
Last Post
JD_F250
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
13
12-17-2009 07:25 PM
Built_Ford_Tough_757
1987 - 1996 F150 & Larger F-Series Trucks
3
07-08-2009 11:24 AM
viperbluelx
1999 to 2016 Super Duty
3
10-03-2007 12:19 PM