Dash Boss?
#1
Dash Boss?
Hey guy's, I currently have a SG II for monitoring my 6.0. I was thinking of upgrading to a Dash Boss because I can add fuel pressure and egt to it. I was doing some reading on the dash boss site about adding fuel pressure. Apparently .5 volt input is needed to make the gauge work. Is this easy to do and wire up? The EGT part looks simple enough.
#2
Hey guy's, I currently have a SG II for monitoring my 6.0. I was thinking of upgrading to a Dash Boss because I can add fuel pressure and egt to it. I was doing some reading on the dash boss site about adding fuel pressure. Apparently .5 volt input is needed to make the gauge work. Is this easy to do and wire up? The EGT part looks simple enough.
Write-Ups by Lilpooh:
"How to" add A/D external ports.
Fuel Pressure Transducer physical installation for PowerStroke
EGT And fuel pressure on a 6.0 PSD
Josh
#4
I recently purchased the fuel pressure sensor for my DashBoss but haven't had a chance to install it yet. Instead of taping into an existing sensor to get the 5Vdc I'm considering installing a 12Vdc to 5Vdc converter. To me this is a cleaner set-up that splicing into another sensor's wiring.
Thread
Thread Starter
Forum
Replies
Last Post
06greenstroker
6.7L Power Stroke Diesel
1
12-04-2017 10:11 AM
motor-man
6.0L Power Stroke Diesel
22
06-14-2010 08:01 PM