Anyone know how hard it is to rebuild this tranny? I found rebuild kits on JBG but some on ebay seem to have more parts to them. Any idea what kinda kit I'm looking for to rebuild it? I have no idea if it works or not.

 

Novak,,,,,

 

I did one a few years ago and thought it was a piece of cake. I took a 4x8 sheet of OSB and framed it out with 1x2. Heard horror stories about losing bearings. I did all my work on the OSB and on the floor. I was a pain doing it that way but when bearing went rolling they didn't roll off to never, never land.

 

They are technically difficult, just heavy sum-biotchs

Josh

 

Hmm. So I opened up the inspection door and it looks new inside o.O no chips or heavy wearas far as I could see. The input shaft isn't loose or anything. I took a short vid of the inside. Anyone wana pm me with their cell and ill text the vid for review to ya? It looks super duper clean!