enclosed trailer floor
Thread Starter
|
Cross-Country
Joined: Sep 2012
Posts: 53
Likes: 0
enclosed trailer floor
i purchased a used 6 x 10' enclosed trailer- (general use) hopefully haul a golf cart soon.... the floor looks a bit worn and warped in some areas- Looks like 3/4" plywood attached to the frame. I would like to swap it out with new plywood- has anyone done this and is it difficult? The other option is to screw down newer wood over it but I am concerned if the first layer gets more worn out- it would be unsafe......recommendations?
Super Moderator
Joined: Aug 2008
Posts: 37,384
Likes: 1,868
From: Frederick, MD
I recommend going with planks like flatbed trailers use if possible. They will last longer and can hold more weight and in the event of a leak won't just come apart.
Before putting down soak them in an oil based paint.
Before putting down soak them in an oil based paint.
Laughing Gas
Joined: Mar 2006
Posts: 1,164
Likes: 2
From: Tri-Cities, TN
With a trailer that small, I would think you'd be fine to use marine-grade 3/4" plywood as it is likely anything you put in there will have a low pounds-per-square-foot impact on the floor. Double layers will be a problem if any moisture gets between the sheets of ply as that will decay extremely quickly and you'll never know until something break through the floor.
Thread
Thread Starter
Forum
Replies
Last Post
75f100hsv
1973 - 1979 F-100 & Larger F-Series Trucks
8
May 31, 2019 12:59 PM
canadajin
All Things Towing
2
Aug 23, 2006 11:08 AM
