Help what can i do ecu
Thread Starter
|
Senior User
Joined: Mar 2008
Posts: 377
Likes: 1
From: robin hood country UK
Help what can i do ecu
Hi i have a 302 efi out of a 1989 ford e150 econoline auto the engine and O/D gearbox will be fitted in a f100 but the problem i have is i am using all the econoline wiring harness but i have managed to snap a pin on the ecu number 60 any idea what pin 60 will i have problems.Or can i use another ecu maybe a standalone one if so what will i need and who will sell one.Or should i swap the efi for a carb thanks part number on the ecu i have is A9J E9TF-12A650-AS2A
FTE Legend
Joined: Jun 2006
Posts: 31,930
Likes: 1,499
From: Ottawa, Ontario
Pin 40 and 60 are the main computer grounds and they're in parallel so it shouldn't make any difference that you lost one of them, try it out and see what happens. If it does present a problem then any 5.0 truck computer for a manual or non computer controlled auto transmission will work.
Posting Guru
Joined: Sep 2008
Posts: 2,379
Likes: 2
Those connectors are known for being brittle as they get older. I had to buy a new one, found on eBay.
Paul...Since 37 & 57 are also parallel, would it be OK to leave one of those disconnected if there was a problem in the connector? Or does the PCM need both of these power feeds at each pin?
Paul...Since 37 & 57 are also parallel, would it be OK to leave one of those disconnected if there was a problem in the connector? Or does the PCM need both of these power feeds at each pin?
Thread
Thread Starter
Forum
Replies
Last Post
Hendrik
Electrical Systems/Wiring
3
Mar 12, 2017 12:18 PM
DJdemon6696
1987 - 1996 F150 & Larger F-Series Trucks
3
Dec 28, 2007 03:46 PM
