zf5 input shaft play
Thread Starter
|
Laughing Gas
Joined: Apr 2009
Posts: 903
Likes: 9
From: melbourne beach, fl
zf5 input shaft play
have a 130k 97 zf5 and just installed a brand new clutch from normal use as this is a f450. Prior to installing the t/o bearing i just wiggled the input shaft to see how much play and noticed that is has some slop. About 1/8" of play, I would venture to guess to replace anything in the trans it must all be removed from the back side? thankx!
Cargo Master
Joined: Nov 2010
Posts: 3,244
Likes: 40
Correct. You have to split the case on the back end and then all the shift rails will come out as an assembly. I believe the preload specs call for 0.02-0.10 mm on the input shaft.
If you are going to do it, just rebuild the entire thing since you have to go in there anyway.
If you are going to do it, just rebuild the entire thing since you have to go in there anyway.
Cross-Country
Joined: Mar 2008
Posts: 98
Likes: 0
Thread
Thread Starter
Forum
Replies
Last Post
jason832
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
6
Feb 11, 2018 06:50 PM
dalberti
Clutch, Transmission, Differential, Axle & Transfer Case
4
Feb 10, 2018 01:57 PM
schnikies79
1983 - 2012 Ranger & B-Series
2
Jul 22, 2009 08:11 AM
