Check Engine Light
#1
Check Engine Light
My service engine light is on. There are two trouble codes that showed up in the diagnostic...P0174 and P071. Both show the MAF as the problem. I changed it and the light is still on. The other potential problem source appears to be the oxygen sensor for bank 2 sensor 1. Does this approach sound right? Where is the the oxygen sensor for bank 2 sensor 1? Thanks
#2
The O2 sensors should be last on the list to even consider replacing
Along with the intake manifold gaskets.
While replacing or cleaning the MAF, the negative battery should be
Disconnected while doing the work.
Then a careful check of any vacuum lines or fittings after the MAF for
Leaks.
PVC and oil cap should also be checked.
Fuel pressure and injector o rings could also cause these codes.
Along with the intake manifold gaskets.
While replacing or cleaning the MAF, the negative battery should be
Disconnected while doing the work.
Then a careful check of any vacuum lines or fittings after the MAF for
Leaks.
PVC and oil cap should also be checked.
Fuel pressure and injector o rings could also cause these codes.
Thread
Thread Starter
Forum
Replies
Last Post
2Fords1Jeep
1997-2006 Expedition & Navigator
12
09-14-2005 04:53 PM