'66 skins on a '73-'79 Floor?
#16
01-13-2013, 06:13 PM
Join Date: Jan 2013
Location: Florida
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone out there make a repro center section for the bed floor for anything up to '96? I measured my '95 and it is the very same measurement as my '66 for the center section. The stamp pattern is different, and the mounting holes would have to be drilled, but I don't care about the stamp and I own drill bits. *L* I found one at LMC truck but they sell the floor with the front & rear rails....don't need the rails, just the sheet metal. Anyone know of anybody who sells it like that?
#17
01-13-2013, 06:48 PM
Does anyone out there make a repro center section for the bed floor for anything up to '96? I measured my '95 and it is the very same measurement as my '66 for the center section. The stamp pattern is different, and the mounting holes would have to be drilled, but I don't care about the stamp and I own drill bits. *L*
I found one at LMC truck but they sell the floor with the front & rear rails.
I found one at LMC truck but they sell the floor with the front & rear rails.
F81Z-9911215-AA (replaced E5TZ-9911215-A & C, E4TZ-9911215-A & EOTZ-9911215-A) .. Bed Pan ~ Use with 8' Styleside Bed ~ Use without dual rear wheels / Obsolete
Last MSRP: $557.32 // Dealer net cost: $334.39 / No Ford Dealer or obsolete parts vendor has any of these part numbers.
Applications: 1980/96 F100/350 & F(Super Duty) w/133/155" wheelbases / 1997 F250/350 & F(Super Duty) w/133/155" wheelbases.
I recall where a member installed one of these newer pans on an earlier truck. The thread is complete with step-by-step pictures.
This was several years ago and he bought it from a Ford dealer, as it was still available back then.
Thread
Thread Starter
Forum
Replies
Last Post
Invader6
1961 - 1966 F-100 & Larger F-Series Trucks
30
06-30-2017 01:01 PM
sgettin
1961 - 1966 F-100 & Larger F-Series Trucks
6
10-17-2009 02:48 AM