C6 QUESTION
Thread Starter
|
Laughing Gas
Joined: Feb 2011
Posts: 1,147
Likes: 6
From: Vine Grove KY
I probably won't get it done until after I move back to Kentucky. I have too many things to do before then. Baby #2 is due in 3 weeks!!
Moderator
Joined: Jan 2001
Posts: 56,984
Likes: 2,738
From: Virginia
I would actually test it out first and see if it really does have a lot of play in the rearend(did you and I missed it?). What if your u-bolts that hold the rear axle to the springs are loose? The bushings in the leaf springs ok?
Thread Starter
|
Laughing Gas
Joined: Feb 2011
Posts: 1,147
Likes: 6
From: Vine Grove KY
I haven't tested it yet. At a glance the bushings don't look bad, but then again neither did the front TTB axle pivot bushings until Gary and I got them axles pulled down and realized the inner sleeve was riding on the the outer sleeve!! I know the u-bolts are tight I checked them a couple times right after I swapped the axle in. I was afraid they would settle somehow and come loose. I will run outside in a litle bit and check out those bushings a little closer.
Thread
Thread Starter
Forum
Replies
Last Post
collinrandle
1973 - 1979 F-100 & Larger F-Series Trucks
13
Oct 20, 2015 05:40 PM
Boba Fett
Clutch, Transmission, Differential, Axle & Transfer Case
4
Dec 26, 2013 08:07 PM
TonyJestis
1987 - 1996 F150 & Larger F-Series Trucks
15
Nov 5, 2012 06:13 PM
notyettoday
Clutch, Transmission, Differential, Axle & Transfer Case
5
Feb 8, 2007 01:55 PM
1978fordf250
Clutch, Transmission, Differential, Axle & Transfer Case
5
Dec 15, 2006 04:49 AM
