Autolite 4100 question
Fleet Owner
Joined: Dec 2009
Posts: 20,678
Likes: 83
From: NorCal
Thread Starter
|
Laughing Gas
Joined: Aug 2011
Posts: 1,116
Likes: 0
Darn. I could easily just convert to an electric choke..but I have the factory manual choke pull **** in my truck and I would like it to be useful
as silly as this sounds. I'm just looking for a carb smaller than 600 cfm to run on my 300 and having no such luck
as silly as this sounds. I'm just looking for a carb smaller than 600 cfm to run on my 300 and having no such luck
Thread Starter
|
Laughing Gas
Joined: Aug 2011
Posts: 1,116
Likes: 0
I've been lookinc at holleys. I'm not partial to edelbrocks or holleys..I've just heard holleys are harder to tune. I have a 600 cfm eddy on my 300/6 right now..I haven't run it yet..but I'm just afraid it may be too much. But..I suppose ill wait and see.
I do not have a 4100 lol I wish..but no. I've been looking on eBay. There are some used ones that need a few parts for about 75.00 on there though
I do not have a 4100 lol I wish..but no. I've been looking on eBay. There are some used ones that need a few parts for about 75.00 on there though
Thread
Thread Starter
Forum
Replies
Last Post
