D60 swap questions
Fleet Owner
Joined: Oct 2005
Posts: 20,786
Likes: 1,751
From: Kentucky
Senior User
Joined: May 2011
Posts: 422
Likes: 0
From: Charm City
Everything bolts right in place, the track arm bracket uses the holes that the passenger side TTB mounting bracket uses. After you unbolt the TTB brackets and remove them, use a hammer and drive out the mounting studs, they are just splined bolts, like a wheel stud.
Senior User
Joined: Jun 2011
Posts: 382
Likes: 0
From: Milford, CT
You need the 60's steering linkage too, the pitman arm is not required.
-Mike
You also need the drivers side u-bolt plate. Runs $110-$145 new. There's a pic in the link in my sig, under Babe>SAS
-Mike
You also need the drivers side u-bolt plate. Runs $110-$145 new. There's a pic in the link in my sig, under Babe>SAS
Thread
Thread Starter
Forum
Replies
Last Post
mando jake
1987 - 1996 F150 & Larger F-Series Trucks
1
Apr 20, 2009 03:43 AM
TeulonF250
Clutch, Transmission, Differential, Axle & Transfer Case
2
Apr 15, 2004 08:00 AM
