E4OD Separator Plate
Thread Starter
|
Freshman User
Joined: Jul 2008
Posts: 29
Likes: 0
E4OD Separator Plate
The first metal plate to go down ( large one ). I am building to be a 1996-1998 setup. I am wondering what the difference is between the two plates from 94 to 97. The plate from the 97 got rusty an now unusable, can I use the 94 plate instead thanks very much Robert
Thread Starter
|
Freshman User
Joined: Jul 2008
Posts: 29
Likes: 0
The gasket goes down then this plate an at tail end there is a reinforcing plate bolted down. Also this plate has square, round, an or triangle notches cut out here at where the reinforcing plate goes. If this doesn't do it I will take a picture of it thanks in advance. Cheers Robert
Thread Starter
|
Freshman User
Joined: Jul 2008
Posts: 29
Likes: 0
http://www.makcotransmissionparts.co...E4OD-4R100.pdf
If ya look down page towards bottom number 747 .
Thanks for the help
If ya look down page towards bottom number 747 .
Thanks for the help
Post Fiend
Joined: Dec 2009
Posts: 15,505
Likes: 18
From: Livoina,La
Thread
Thread Starter
Forum
Replies
Last Post
