does this trans look normal?
Thread Starter
|
Posting Guru
Joined: Mar 2012
Posts: 1,011
Likes: 4
From: MI
does this trans look normal?
Cant get the input shaft to go into the input bearing. near the end of the day, i put the cross member in to see where my reference is. I was trying to put it in at this height:
thatlooks like it lines up well with the block to bell housing..but way too big a gap.
once i set it down on the crossmember, it looks like this. and it seems it sits on the crossmember at a bit too much of an angle..
thatlooks like it lines up well with the block to bell housing..but way too big a gap.
once i set it down on the crossmember, it looks like this. and it seems it sits on the crossmember at a bit too much of an angle..
Senior User
Joined: Apr 2012
Posts: 240
Likes: 0
From: Prosser, WA
well dont quote me on that, but i have one thats flat, and it didnt work on my zf 4wd. and i think it came out of the 2wd truck and forgot the truck was 2wd when i snagged it cause it was in the bed.
Rob
Rob
Thread
Thread Starter
Forum
Replies
Last Post
pineconeford
1948 - 1956 F1, F100 & Larger F-Series Trucks
6
Jun 10, 2017 10:52 AM
vntgtrk
1948 - 1956 F1, F100 & Larger F-Series Trucks
11
Nov 16, 2012 04:15 PM
