400 water temp sensor
Thread Starter
|
Junior User
Joined: Dec 2000
Posts: 88
Likes: 1
From: Garden City Kansas
400 water temp sensor
Well finally got my holley F.I. for my 400. Got to putting it together and had to stop at the temp wiring. Where can I put another sensor at? I put the new one in the stock place but I need a place to put my guage sendor. I was going to t it in but then read that it isn't accurate doing this. I thought about then putting it inline with my heater hose and was told that this wasn't accurate either. I was then going to put it in the place where there is a plug on my water pump but just broke my allen wrench trying to remove the plug. So where can I put my sensor at without having to do anything difficult like drilling a hole in my block. Thanks for any help
Richard
Richard
Elder User
Joined: Feb 2001
Posts: 829
Likes: 0
From: Porterfield
400 water temp sensor
Good Chance that that plug in the water pump has some type of locktight on it .. my have to heat it up a little.
And if it comes down to it you could always drill out that plug and then chase the threads ....
And if it comes down to it you could always drill out that plug and then chase the threads ....
Thread
Thread Starter
Forum
Replies
Last Post
ol_red92
1987 - 1996 F150 & Larger F-Series Trucks
7
Feb 25, 2015 05:48 AM
foxracing0934
1994.5 - 1997 7.3L Power Stroke Diesel
3
Jan 3, 2010 08:06 PM
