Frustrated 04
#1
Frustrated 04
I just had my 04 5.4l engine rebuilt. Ive driven it about 500 mi and it started running rough at a stoplight. I tapped the accelerator and it started running good again but service engine light came on. I pulled the codes and they were p0022,po345,p0340,and p0430. It has done this several times now. Everything was replaced including the phasers, except for the camshaft sensors. Could they cause this problem?
Any input would be very appreciated.
Any input would be very appreciated.
#2
#3
#4
Frusrtated 04 newly rebuilt engine with camshaft position sensor codes.
poo22, p0345, p0340, p0430. Engine is a 04 5.4L 3V. Ive driven the truck about 500 mi.
After it is warmed up, occasionally when I come to a stop it starts running rough and sometimes dies. I tap the accelerator or restart it and it starts running fine again.
The camshaft position sensors were not replaced when the engine was rebuilt.
Does anyone know how to test these? or could the valve timing be off a tooth?
Any suggestions would be greatly appreciated.
poo22, p0345, p0340, p0430. Engine is a 04 5.4L 3V. Ive driven the truck about 500 mi.
After it is warmed up, occasionally when I come to a stop it starts running rough and sometimes dies. I tap the accelerator or restart it and it starts running fine again.
The camshaft position sensors were not replaced when the engine was rebuilt.
Does anyone know how to test these? or could the valve timing be off a tooth?
Any suggestions would be greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
Redneck Packrat
2004 - 2008 F150
9
02-27-2019 02:58 PM
Beach_Bob
Explorer, Sport Trac, Mountaineer & Aviator
3
09-02-2008 07:43 AM