CEL Issue
Thread Starter
|
New User
Joined: Nov 2008
Posts: 17
Likes: 0
From: Alexandria, va
CEL Issue
Hello everyone. My question is a couple weeks ago I replaced all spark plugs and my #7 ignition coil (due to misfiring). A few days after that everything was fine. Then the CEL came on again and that good old shudder started back up. I ran the codes and it said #7 misfire. So I went back an checked all connections to make sure I didn't miss anything and the shudder would come and go. Usually at its worst the first 5 min of driving. So I ran the codes again and this time I got #8 misfiring and possibly a bad EGR valve. I was going to hit Autozone tomorrow to get the parts but when I got in my truck this morning it was like new. No CEL and no shudder. Anyone have any suggestions on where I should start? Also I noticed a hose running into what I thought was the intake area was broken. It's on the drivers side and has a second hose running next to it. It seems that it's just f
Air going through it. Is that a heater hose? I just to make sure I get the right part on that one. Thanks everyone!
Air going through it. Is that a heater hose? I just to make sure I get the right part on that one. Thanks everyone!
Thread
Thread Starter
Forum
Replies
Last Post
dborns
Escape & Escape Hybrid
14
Jul 7, 2019 12:04 AM
1999XLT
1997 - 2006 Expedition & Navigator
2
Oct 13, 2002 04:02 PM
