Slippy Rubber
Thread Starter
|
Posting Guru
Joined: Aug 2002
Posts: 1,729
Likes: 2
Slippy Rubber
Well I made a big mess this afternoon, the front half of my valve cover gasket (felpro rubber) pushed out... 
needless to say it made a pretty good mess under the hood. I took the cover off and put on a new gasket (same felpro). I noticed the cover is warped a bit, so I'm going to go ahead and get my alumiumn ones.
My question is has anyone ever used the Ford Motorsport Black Cast Alumiumn valve covers from Jegs? Just curious on any yea's or nay's. Gasket, cork or stick w/rubber? If I go rubber I kinda want to go w/studs to help keep it lined up while installing. Any good stainless ones? Sorry for the long post, Thanks for the input!
needless to say it made a pretty good mess under the hood. I took the cover off and put on a new gasket (same felpro). I noticed the cover is warped a bit, so I'm going to go ahead and get my alumiumn ones. My question is has anyone ever used the Ford Motorsport Black Cast Alumiumn valve covers from Jegs? Just curious on any yea's or nay's. Gasket, cork or stick w/rubber? If I go rubber I kinda want to go w/studs to help keep it lined up while installing. Any good stainless ones? Sorry for the long post, Thanks for the input!
Thread
Thread Starter
Forum
Replies
Last Post
BackyardIdaho
1973 - 1979 F-100 & Larger F-Series Trucks
12
Feb 20, 2016 09:18 PM
dustinova
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
9
May 4, 2007 11:38 PM
Jermafenser
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
8
Apr 22, 2007 12:24 AM
gtex
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
12
Nov 4, 2003 02:51 PM
